NetBackup Appliance - Reonfigure bond from the appliance's CLISH

Unconfigure bond and reconfigure bond from the appliance's CLISH

Problem
Need to remove the current network bond or reconfigure the bond on the NetBackup appliance

Cause
No longer want to use the current bond or need to reconfigure the network bond

Solution
1. Network > Show Status
Determine what is plugged in

2. Network > Show Configuration
Determine the configuration

3. Network > Unconfigure bond0
This step will remove the IP address from bond0

4. Network > LinkAggregation Disable bond0
This step will remove the Bond

5. Network > Show Configuration
Determine the configuration has been deleted

6. Network > Configure 10.200.x.x 255.255.x.x 10.200.x.1 eth2,eth3,eth4,eth5
This step is an example and will create new bond0 interface on eth2, eth3, eth4 and eth5

7. Network > Show Configuration
This will show your new configuration with your new bond0

8. Network > Show Status
This will show the details of the bond and the ports


Applies To NetBackup 5220 and 5230 appliances

https://www.veritas.com/support/en_US/article.000024787